Makerbot Replicator 2 Extruder Upgrade Kit | Bondtech
Bondtech Upgrade Kit for Makerbot Replicator 2
- Bondtech Dual Drive gears
- Single nozzle
- Adjustable tension for fine-tuning filament pressure
- High-performance material feeding system
- Housing parts are professionally SLS printed in polyamide for maximum strength and precision
- Replaces the original feeder and coldblock
- The original motor are used
- PTFE feed tube is held securely in place with an industrial 6mm push-fit connector for reliability
- Installs in about half an hour with standard tools available
- Full installation guide available here (the installation guide is for a Makerbot Replicator 2X but follows the same steps)
This block has an M6x1.0 thread through the coldblock for the factory default heatbreak. Please verify that your heatbreak fits before placing your order.
On the factory setup there is a low height nut both over and under the coldblock. With this setup, the top nut needs to be removed.