Cable - Stepper Motor to Dupont 4 pin with Latch | PBX
Extension Cable, Bondtech NEMA 17 stepper motor to Dupont 4 pin with latch.
This cable is for connecting a Bondtech stepper motor to the Prusa MK3 or any other 3D printer that uses a Dupont 4 pin connector with latch.
- Approximately 26 inches in length.
- Nema 17 stepper motor 6-pin connector to Dupont 4-pin connector with latch.
- This cable is by default wired for the Bondtech 40mm geared Nema17 motor.
Please make sure that it follows the schematics for your application.
Controller Side Motor Side
PIN 1 —————–PIN 1
PIN 2 —————– PIN 4
PIN 3 —————– PIN 3
PIN 4 —————– PIN 6