Creality CR-10S Pro Kit | Bondtech

  • Creality CR-10S Pro Kit | Bondtech
  • Creality CR-10S Pro Kit | Bondtech
  • Creality CR-10S Pro Kit | Bondtech
  • Creality CR-10S Pro Kit | Bondtech
Frequently bought together:


Bondtech BMG Extruder Upgrade Kit for Creality CR-10S PRO

The Bondtech extruder allows for a more reliable printing with all sorts of filaments and the dual drive system ensures that the extruder never looses grip of the filament. 

This kit contains no motor, the original motor is used. 


  • Extruder
  • Sensor Spacer
  • Thumbscrew
  • Motor Gear and M3x3 Set Screw
  • 4 pcs Countersunk M3x6 screws
  • Bondtech Cable Clip

Lower Current Recommended

Due to the gearing ratio, the stepper motor can push filament with such force that the Bowden tube can be pushed out if there is a clog. To avoid such damage, Bondtech recommends lowering the stepper motor current to near half the original current. Check out this step-by-step guide for information.

The Bowden tube is securely held in place by the 4mm industry standard integrated push-fit connector.

Reducing Filament Jams

There is now a near to 0.1mm gap between the Bondtech gears and SLS 3D printed housing that prevents a filament jam. An additional short PTFE Tube is added between the extruder and the filament sensor to allow for easier filament loading and unloading.

SLS Printed Housing

The housing parts are professionally SLS 3D printed with polyamide for maximum strength and precision. Due to the slightly higher geometry of the extruder, the total print height will be 385mm.

Firmware Update

The Creality3D firmware needs to be updated in order to use this upgrade kit. The w-steps need to be updated to 415 and the total print height is set to 385 mm. Please see the installation guide on how to do it.

Find the installation guide here. 


View AllClose