Creator Pro 2

  Bed Heater Mounting Hardware set This hardware is for mounting the PCB bed heater to the build plate on the below listed Flashforge 3D printers. Includes:Bolts (5 pcs)Nuts (5 pcs) Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2DreamerDreamer...

Socket Head Cap Screw - Low Head - Stainless Steel  Used to clamp the heater cartridge in the heater block Includes: Socket Head Cap Screw - Low Head (4 pcs) Size: M3x8 Fits:Guider 2S HTCreator Pro 2Creator Max 2Robo E3 Pro

Hotend Screw Assortment  A selection of screws for the extruder assembly. Notes: This is a selection and not a complete replacement set.Color of screws may be different than shown. Fits:Creator Pro 2Creator Max 2 Includes:M3x16 socket head cap...

Socket Head Cap Screw - 4 pack Size: M3x16 Includes: M3x16 socket head cap screw (4 pcs) Used in the following locations on the printers listed below:Extruder to carriageFan to heatsinkStepper motor mounting. Fits:Creator Pro 2Creator Max 2

Replacement Magnet sheet for 154*232mm DFlex™ Build Plate Includes: Sheet magnet with adhesive backing (1 pcs) Size: 154*232mmMax temperature: 90c Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2InventorDreamerDreamer NX

PB Select Nozzle Coat™  Nozzle Coat is a water-based PTFE nano coating for your nozzle & heater block. Using Nozzle Coat will help reduce the amount of plastic that sticks to the exterior of your nozzle & heater block...

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Note: Power supply is not included

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Specs:Wire:18 AGWLength: 72 inches (approximately) Max Operating Temp: 105°C (221°F)

M4X4 Set Screw Used to secure the heater cartridge and heatsink of many Flashforge 3D printers. Includes: M4x4 set screw (1 pcs) Specs:12.9 GradeCup PointUses 2mm Hex Key Driver (not included) Fits:FinderFinder 2Guider 2Guider 2S...