Flexplate System - R2 | Robo 3D

R2 BuildTak FlexPlate System 

Please Note: Standard BuildTak 8x8 FlexPlate systems will not fit the Robo R2. This FlexPlate system is custom made for an exact fit on your Robo R2 3D printer. 

Easily remove 3D prints from your Robo R2 by removing the spring steel plate, flexing it, and popping the print off. Once finished, add the spring steel plate back to magnetic base and continue 3D printing. It's simple and makes the print removal process much easier. 

Includes:

• Magnetic base that is adhesive-backed for easy installation
• FlexPlate - a spring-steel plate with tab for easy removal off of platform
• Custom Robo BuildTak sheet to place on the spring-steel plate.
• 2 Silicon FlexPlate grippers

Print bed not included

Here is a great write up for installing the FlexPlate System on your R2 printer - posted by tkoco (thanks again, tkoco!)
http://community.robo3d.com/index.php?threads/flexplate-system-for-the-r2-printer.23495/

You can buy additional R2 FlexPlates here for fast swapping of print surfaces.

Note: If your R2 print bed has a PEI sheet, carefully use the scraper to remove the PEI sheet starting from one corner of the print bed. Then, pull off the entire PEI sheet. Next, hand-rub or use Goo Gone to remove any excess adhesive before applying on the flex plate magnetic base. Finally, place the spring-steel plate on top of the flex plate magnetic base. You are now ready to begin printing!