R1+ Thermistor Cable (wire)
Runs from mainboard to thermistor.Will also work for the heatsink fan or print cooling fan but pay attention to the orientation of the plug (at the mainboard)...
3mm Bed Magnets for R1/+ Glass Bed
Apply using epoxy and these clamps for best results.
Includes: Magnet (4 pcs)
Fits:Robo R1Robo R1+
Note: These magnets are 3mm thick and do not work...
Mainboard to Uptown Board Wire (cable)
This cable runs from the C2 mainboard to the extruder heater connection on the uptown board.
Includes: Cable (1 pcs)
Fits: C2
Print Bed Plastic Housing for Robo R2
Includes: Plastic bed housing (1 pcs)
Notes: This is the plastic housing only.Does not include screws: Reuse the screws from your old bed. Does...