3D-Fuel HydroPro™ Water Soluble Support Material - 1.75mm 500g

HydroPro™ dissolves quickly - it only needs to be soaked for 1-2 hours to easily work supports off by hand, or 2-6 hours to dissolve completely.

It is easier to print with than other support materials, non-toxic and fully biodegradable.

Note: Because HydroPro breaks down in water, it is sensitive to high levels of humidity in the air. For best results store unused HydroPro filament in a sealed container with desiccant.

HydroPro Support Material Print Settings

Print Temp: 215 – 230c
Bed Temp: 45 – 60c