Magnetic Heatbed Assembly (12v) for MK2.5/S | Prusa Compatible

 PB Select™ Heated Bed Assembly

This is a Prusa compatible bed. If you want the genuine Prusa bed, please click here.

This 12V magnetic heatbed is ONLY compatible with the MK2.5 and MK2.5S .

Please Note:
NOT compatible with the MK3/S/+
Flexible Spring Steel sheet is NOT included

Includes:

• Magnetic heatbed MK52 12 volt (1 pcs)
• Heatbed-Einsy power cable (screw-attached) (1 pcs)
• Heatbed thermistor E3D (already mounted and fixed in place by the aluminum and kapton tapes) (1 pcs)
• Textile sleeve (Length: 300 mm, Width: 5 mm) (1 pcs)
• Heatbed cable cover (1 pcs)
• Heatbed cable cover clip (1 pcs)
• Nuts: M3 nylon lock (2 pcs)
• Nuts: M3 (3 pcs)
• Socket head screws: M3x9 (5 pcs)
• Flat head screws: M3x6 (6 pcs)
• Washers: M3 flat (3 pcs)

Specifications:

• Height: 264 mm
• Width: 254 mm
• Thickness: ~3 mm
• Maximum working temperature: 120°C
• Maximum recommended temperature: 110°C
• Voltage: 12 volts
• Current: 13A
• Magnets: N35UH Neodym block magnet (28 pcs), attached. - these magnets are not quite as strong as the Original Prusa magnets, but still do a sufficient job of holding the print surface in place.

Fits:

• MK2.5
• MK2.5S

To replace this part, please consult the Prusa Assembly Manuals. Make sure to follow the manual for your printer model