MK2.5/S

3mm Nylon Filament  This 3mm nylon filament is used in the wiring harness of Prusa i3 printers. The length is 50cm which is the proper length for the extruder wiring harness. It can be cut down to 30cm if you need it for the heat...

  Basics of 3D Printing with Josef Prusa  "Basics of 3D Printing" takes you on a tour through the 3D printing world. This is a print version, the e-book can be downloaded for free at prusa3d.com. Starting from the history of...

623ZZ Roller Bearing Size: 3x10x4mm A nice quality roller bearing with metal covers to keep dirt out of the rolling elements

2GT Timing Belt for Prusa X Axis Includes: Timing belt for X Axis (1 pcs) Specifications: Type: 2GT Length: 850 mm Width: 6 mm Pitch: 2 mm Fits: MK2 MK2S MK2.5 MK2.5S MK3 MK3S MK3S+   To replace this part, please consult the...

2GT Timing Belt for Prusa Y axis Includes: timing belt for Y axis (1 pcs) Specifications: Type: 2GT Length: 650 mm Width: 6 mm Pitch: 2 mm Fits: MK2 MK2S MK2.5 MK2.5S MK3 MK3S MK3S+ To replace this part, please consult the...

Prusa Compatible Print Cooling Fan This plug-and-play aftermarket fan for the Prusa MK2 series is a little more powerful than the stock fan and comes with a genuine Molex™ connector pre-installed  Includes: 12 volt print fan...

Bondtech Drive Gear Set for Prusa 3D Printers Comes as a set consisting of a primary drive gear, a secondary gear, bearings and shaft. Includes:  Bondtech gear with a grub screw (1 pcs) Bondtech gear without a grub screw (1 pcs) Bearings (2...

Boron Nitride Thermal Paste (BN Paste) Thermal paste improves heat conduction and heat distribution in the hotend. Contains high quality ZYP™ Boron Nitride and proprietary binders which reduce cracking and flaking when dried. Features:Use...

Brass Heater Block Fits: E3D V6 RepRap Prusa i3

PB Select™ Heated Bed Power Cable for Prusa This is the cable that runs from the Rambo board to the heated bed. Please Note: ONLY compatible with the heated beds with detachable power cable. NOT compatible with heated beds where the power cable...

PB Select™ Prusa V-Cable Adapter MK2.5 Noctua Reduction Cable. Needed to install the a 3 wire fan on the MK2.5 and MK2.5S

Prusa IR Filament Sensor Cable Includes: IR filament sensor cable (1 pcs) Fits: MK2.5S To replace this part, please consult the Prusa Assembly Manuals. Make sure to follow the manual for your printer model