PolyDissolve S1 - Water Soluble Support Material - 2.85mm | CLEARANCE
PolyDissolve S1 - Water Soluble Support Material
PolyDissolve™ S1 is a PVA based water dissolvable support for PLA, TPU, PVB and Nylon based filaments from our portfolio. It is specifically engineered to have a perfect interface with these materials while also displaying good solubility.
How long does it take to dissolve?
It can take 6-12hours to fully dissolve depending on your setup.
You can speed up the process:
- By increasing the water temperature
- By changing the water regularly
- By adding a pump to make the water flowing
These settings are recommended by Polymaker and are meant as a starting point to help find your optimal print settings. They should work for most 3D printers; however, you may need to experiment outside these ranges.
Printing Temperature: 215˚C - 225˚C
Bed Temperature: 25˚C - 60˚C
Printing Speed: 30mm/s - 40mm/s
Retraction Distance: 1mm
Retraction Speed: 20mm/s
Retraction Distance: 3mm
Retraction Speed: 40mm/s
Drying Settings: 80˚C for 12h
(Only if the material has absorbed moisture)
PolyDissolve™ S1 is very hygroscopic, please make sure to use a dry box.