Prusa I3 MK3S Mosquito Upgrade Kit | Bondtech
Bondtech Extruder Upgrade for Mosquito Hotend on Prusa i3 MK3S
This upgrade kit is very similar to the previous MK3S kit, with some small differences.
The design changes include:
- an optimization of the cooling air channel - it is narrower now to focus the air flow on the Mosquito’s heatsink
- This tighter space is also used to hold the hotend in place during nozzle changes, so the user can use one single hand to change the nozzle.
- The air shroud was also redesigned to minimize the thermal runaway caused by the start of the part cooling air flow.
- A new part is included: the hotend adapter, 3D printed with SLS.
Please Note: this upgrade kit does not include the Mosquito Hotend.
This Upgrade Kit requires extra parts to install (click here for the X-Carriage Kit).
This X-Carriage is the same as the one used for the previous model.
Part number : EXT-KIT-69
Net weight : 378g
Gross weight : 389g
Package Size : 137x94x65mm
Gearing ratio : 3:1
E-steps value : 830
Extruder Housing: SLS Printed parts in Polyamide 12