Robo E3 Pro

3D Print Removal Tool - Scraper Includes: Scraper (1 pcs) Length: 175mmBlade width: 39mm

Air Duct Screw (M3x8) Guider 2/2S, Inventor 2, Finder Holds the plastic air duct in place. Includes: M3x8 screw (2 pcs) Fits:Guider 2Guider 2S HTInventor 2FinderRobo E3 Pro

Boron Nitride Thermal Paste (BN Paste) Thermal paste improves heat conduction and heat distribution in the hotside and coldside. Contains high purity Boron Nitride and proprietary binders which reduce cracking and flaking when dried...

Brim Scraper (Mini Scraper) We find this tool handy for removing the brim, and purge lines from the build plate. Includes: Brim Scraper (1 pcs)

Socket Head Cap Screw - Low Head - Stainless Steel  Used to clamp the heater cartridge in the heater block Includes: Socket Head Cap Screw - Low Head (4 pcs) Size: M3x8 Fits:Guider 2S HTCreator Pro 2Creator Max 2Robo E3 Pro

PB Select™ Ball End Hex Wrench - L Wrench Includes: Hex wrench (1 pcs) Size: 2.5mm

*Clearance item - no returns  Blemished  These rolls of tape are wound slightly off-center, however the tape is good and fully usable.  Heat Resistant Kapton Tape Use this tape to secure the insulation to your Flashforge heater...

PB Select Nozzle Coat™  Nozzle Coat is a water-based PTFE nano coating for your nozzle & heater block. Using Nozzle Coat will help reduce the amount of plastic that sticks to the exterior of your nozzle & heater block...

PEI Print Surface Adhesive backed. Can be cut to size for smaller beds. Includes: PEI Sheet (1 pcs) Specifications:Material: ULTEM™ 1000Dimensions: 264x306mmThickness: 175um Fits: Guider 2Guider 2S HTGuider 3 -  Note: this is a...

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Note: Power supply is not included

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Specs:Wire:18 AGWLength: 72 inches (approximately) Max Operating Temp: 105°C (221°F)

M4X4 Set Screw Used to secure the heater cartridge and heatsink of many Flashforge 3D printers. Includes: M4x4 set screw (1 pcs) Specs:12.9 GradeCup PointUses 2mm Hex Key Driver (not included) Fits:FinderFinder 2Guider 2Guider 2S...