StoneFil Pottery Clay 1.75mm 50g Sample | Formfutura
StoneFil Pottery Clay - 1.75mm 50g Sample
- PLA based filament
- 50% stone powder filling
- Stonefil is ±37% heavier than average PLA filament
StoneFil Print Settings
These settings are recommended by Formfutura and are meant as a starting point to help find your optimal print settings. They should work for most 3D printers; however, you may need to experiment outside these ranges. If you find settings that work better with your printer, feel free to let us know and we will be happy to post them.
Experience Level: Intermediate
Nozzle Size: ≥ 0.4mm
Layer Height: Stonefil really adheres to the bed and can be difficult to remove. Increase 1st layer height and/or use blue painter's tape to avoid this.
Print Temp: ±200 - 240° C
Bed Temp: ±0 - 60° C
Print Speed: High / Medium
Fan Speed: 50-100%
Flow Rate: ±110%
Retraction: Yes - 5mm
Print Surface: GeckoTek, BuildTak, Kapton Tape.