Description
The Gripper
Created specifically to hold the E3D V6 and Lite 6 heater block firmly when tightening nozzles. It's small and lightweight, and easy to hold in place, with cutouts to avoid the thermistor and heater cartridges.
It has a cutout through the middle of the wrench, so you can get the appropriate sized socket in there to snug up your nozzle.
In addition, the heater block cutouts are mirrored on the other side of the wrench making reverse orientations of the heater block just as easy to tighten. Just choose the side of the wrench that matches your hotend orientation, and you are good to go!
Includes: Gripper wrench (1 pcs)
Note: Hotend not included
WARNING Since this is aluminum, and conductive, make sure that any uninsulated wires are well enough out of the way so as to not touch the wrench and cause a short.
We recommend heating the hotend to the proper temp, shutting off the printer and then immediately tightening the hotend. This follows the best practice of always having the power off when working on your printer.
