Creator Pro

  Bed Heater Mounting Hardware set This hardware is for mounting the PCB bed heater to the build plate on the below listed Flashforge 3D printers. Includes:Bolts (5 pcs)Nuts (5 pcs) Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2DreamerDreamer...

PB Select™ Heatsink Includes: Heatsink (1 pcs) Fits:Creator ProCreator MaxDreamerDreamer NXInventor

PB Select™ Ball End Hex Wrench - L Wrench Includes: Hex wrench (1 pcs) Size: 2.5mm

Screws for Creator Pro hotend assembly A selection of screws for the hotend assembly. Includes: M3x6 socket head cap screw (4 pcs)Wire support bracket to cold block M3x8 socket head cap screw (3 pcs)Blower fan shroudExtruder to...

Heat Resistant Kapton Tape Use this tape to secure the insulation to your Flashforge heater block. Includes: Tape roll (1 pcs) Width: 5mm Length: 33 meters

Motor Mount Bolt for Creator Pro, Inventor and Dreamer Holds the fan, heatsink and motor to the mounting block Includes: M3x40 socket head cap screw (4 pcs) Size: M3x40 Fits:Creator ProCreator MaxInventorDreamer Note: These do not fit the Dreamer NX...

Replacement Magnet sheet for 154*232mm DFlex™ Build Plate Includes: Sheet magnet with adhesive backing (1 pcs) Size: 154*232mmMax temperature: 90c Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2InventorDreamerDreamer NX

MK10 Brass Nozzle for PTFE Lined Hotend Includes: Nozzle (1 pcs) Size: Select Above Fits:Flashforge Guider 2 (not high temp version)Flashforge InventorFlashforge Inventor 2SFlashforge Creator ProFlashforge Creator MaxFlashforge...

MK10 Brass Nozzle (for Microswiss All Metal Hotend Only) Note: Will not fit the stock PTFE lined hotend. This nozzle has completely different internal dimensions to work with the Microswiss thermal barrier tube...

PB Select Nozzle Coat™  Nozzle Coat is a water-based PTFE nano coating for your nozzle & heater block. Using Nozzle Coat will help reduce the amount of plastic that sticks to the exterior of your nozzle & heater block...

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Note: Power supply is not included

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Specs:Wire:18 AGWLength: 72 inches (approximately) Max Operating Temp: 105°C (221°F)

M4X4 Set Screw Used to secure the heater cartridge and heatsink of many Flashforge 3D printers. Includes: M4x4 set screw (1 pcs) Specs:12.9 GradeCup PointUses 2mm Hex Key Driver (not included) Fits:FinderFinder 2Guider 2Guider 2S...

Flashforge Extruder Fan Spacers These are the spacers that reside between the extruder fan and heatsink on some Flashforge 3D Printers. Includes: Spacer (4 pcs) Fits:Creator ProCreator MaxDreamerDreamer NXInventor