Tools

Tools

Here is a selection of 3D printing tools that we find handy around the shop.

  • On Sale
    Adjustable Wire Strippers Adjustable Wire Strippers Holding

    Adjustable Wire Strippers/Cutters

    Other

    Now: $7.99
    Was: $9.99
    Adjustable Wire Stripper I use these adjustable wire strippers in our shop when adding electronics to my 3D printed items (like these battery adapters). I like to have a few around, each set to a different gauge of wire. That...
    Now: $7.99
    Was: $9.99
  • NOGA replacement blade Deburr tool replacement blade

    Blade for 3D Print Edge Cleanup Tool - Fine Tip | NOGA

    NOGA

    $3.99
    NOGA Replacement Blade - Fine This blade has a smaller tip then the blade that comes standard on the brim and edge cleanup tool, allowing you to clean smaller areas, if needed. Note: This is the blade only, handle not included. Buy the full tool here.
    $3.99
  • ZYP™ Boron Nitride Thermal Paste Slice Engineering Boron Nitride Thermal Paste

    Boron Nitride Thermal Paste | Slice Engineering

    Slice Engineering

    $10.00
    ZYP™ Boron Nitride Thermal Paste from Slice Engineering One 5 cc syringe  Applicator included Thermal paste improves heat conduction and heat distribution Boosts heat dissipation from the hot section of the heater...
    $10.00
  • 3D print edge cleaning tool 3D print hole cleaning tool

    Brim and Edge Cleanup Tool for 3D Prints

    NOGA

    $12.95
    3D Print Cleanup Tool for Edges This tool is great for cleaning the brim off the long, straight edges of your 3D prints. I find it easier to use than an Exacto knife, because the blade doesn't dig into the plastic print as easily. The swivel head makes...
    $12.95
  • Otis Brush

    Cleaning Brush

    $1.99
    Otis Cleaning Brush Nylon bristle brush. Handy for cleaning out extruder drive gears.  
    $1.99
  • Synthetic Oil with PTFE

    Synthetic Oil with PTFE, 4oz | Super Lube™

    Super Lube

    $6.95
    Synthetic Oil with SYNCOLON™ (PTFE) This is a great oil to use on your linear rails or anywhere else you need good lubrication 4 oz bottle SAE Grade 85W Temperature range of -45°F to 450°F (-43°C to...
    $6.95
  • 3D Printer Tube Grease Robo3D

    Tube Grease | Robo3D

    Robo 3D

    $8.00
    Tube Grease for lubing the rails, rods and ball screws of your 3D printer. This is the same grease that comes stock with the Robo 3D printers.
    $8.00