Printer Parts

  Flashforge Timing Belt Belt for Z Axis. Length: 672mm Includes: Belt (1 pcs) Fits:Adventurer 3 (all versions)Monoprice VoxelRobo E3 Note: Item may differ from picture

Bambu Lab Z Belt for X1 and P1 Series Printers The Z belt is a close drive belt with a pitch length of 1142mm, it is installed at the bottom of the Bambu Lab X1/X1C printer. Its main function is to transmit the motion of the Z motor to the three...

  Flashforge Z Belt Tensioner - Idler Pulley Tensioner bracket for Z-axis belt. Includes: Frame (1 pcs) Idler (1 pcs)Axial (1 pcs)Screws (2 pcs) Fits: Adventurer 3 (all versions)Monoprice VoxelRobo E3

   Like New  - Removed from new or lightly used printers.  Z Bracket Set These brackets are located at the top and bottom of the z axis and hold the linear rods and leadscrew in place.  Includes: Top bracket (1...

Idler Side Z Axis Carriage for Robo R1+ Replacement Z Carriage for the idler side Z-axis (non motor side) Includes: Carriage (1 pcs) Location: Idler Side Fits: R1+ Note: This is the carriage only, it does not...

Motor Side Z Carriage for Robo R1+ Replacement z axis carriage with motor mount for Z-axis. Includes: Carriage (1 pcs) Location Motor Side (1 pcs) Fits: R1+ Note This is the carriage only, it does not include: bearings, leadscrew...

   Used Item  Removed from low hour 3D printer.  Flashforge Z Limit Switch (Endstop) Cable Includes: Cable (1 pcs) Fits: Creator Pro 2Creator Max 2

   Used Item  Removed from low hour 3D printer.  Flashforge Z Limit Switch (Endstop) Cable Includes: Cable (1 pcs) Fits:Creator ProCreator MaxDreamerDreamer NXInventor

Aluminum Alloy Coupling - 2 Pack Anodized aluminum coupling for joining 5mm motor shaft with 8mm leadscrew. Specs: 5mm ID -side A 8mm ID - side B 13.8mm OD 25mm length Includes: Coupling (2pcs) Setscrew (2 pcs) Fits:  Ender-3...

Robo R1+ Z Stabilizer Brackets Includes: Brackets (2 pcs) Fits:Robo R1Robo R1+ 

Robo R1+ Z Stop Brackets  Includes: Bracket (2 pcs) Fits:Robo R1Robo R1+ 

Z-Axis Tensioner for Bambu Lab X1 Series and P1 Series Printers The Z tensioner is a part that mounts on the bottom of the printer and is used to tension the Z timing belt. Includes: Tensioner (1 pcs)Hex screw (1 pcs)Hex...

  Základy 3D Tisku S Josefem Průšou - Czech  Czech Version  "Basics of 3D Printing" takes you on a tour through the 3D printing world. This is a print version, the e-book can be downloaded for...