Robo R2

Cable - IR Sensor to Downtown Board For connecting IR Bed Level Sensor to Downtown Board  Includes: Cable (1 pcs) Fits: Robo R2Robo C2

Extruder Motor Cable for Robo R2 and C2 3D Printers Includes: Cable (1 pcs) Fits: R2C2

Z Motor Cable This cable is for the R2, but also works for the C2 and R1/+ Includes: Cable (1 pcs) Length: 600mm Fits: R2C2R1/+

X Endstop (limit switch) Cable Includes: Cable (1 pcs) Fits: R2

X Stepper Motor Cable for Robo 3D Printers This cable is for the R2 X motor but also fits the Robo C2 and R1/+ Includes: Cable (1 pcs) Length: 700mm Fits: R2C2R1R1+

Y Endstop (limit switch) Cable Includes: Cable (1 pcs) Fits: R2

Z Endstop (limit switch) Cable Includes: Cable (1 pcs) Fits: R2

Robo Extruder Wiring Harness  Runs from mainboard to extruder Includes: Wiring harness (1 pcs) Fits: R2

HDMI Cable Board-to-LCD connection cable Includes: Cable (1 pcs)  Fits: Robo R2Robo C2    

Raspberry Pi Power Cable This is the cable that runs from the mainboard to the Raspberry Pi. It is a little shorter then the stock R2 cable, but will reach with slightly less excess wire. Includes: Cable (1 pcs) Fits:Robo R2Robo C2

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Note: Power supply is not included

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Specs:Wire:18 AGWLength: 72 inches (approximately) Max Operating Temp: 105°C (221°F)

Ribbon Cable - Uptown to Downtown Board  Includes: Cable (1 pcs) Fits:Robo R2Robo C2

Terminal Block Plug 5.08mm Includes: Plug (1 pcs) Specs:2 position20 ampSafety approval:  Shade of green may be different than photo

Terminal Block Plug 5.08mm Includes: Plug (1 pcs) Specs:4 position15 amp