Adventurer 5M & 5M Pro

PB Select Nozzle Coat™  Nozzle Coat is a water-based PTFE nano coating for your nozzle & heater block. Using Nozzle Coat will help reduce the amount of plastic that sticks to the exterior of your nozzle & heater block...

  Nozzle Connection Board (PCB Board) This is the board the nozzle plugs into.  Includes: Nozzle connection board (1 pcs) Fits:Adventurer 5MAdventurer 5M ProRobo E4  

  Power Supply Unit (PSU) Includes: PSU (1 pcs) Fits:Adventurer 5MAdventurer 5M ProRobo E4

3D Print Cleanup Tool - RB1000 Deburring Tool This deburring tool is great for cleaning the brim off the long, straight edges of your 3D prints. We find it easier to use than an Exacto knife, because the blade doesn't dig into the plastic print as...

*Clearance item, no returns Tube Grease for lubing the rods and ball screws of your 3D printer. This is the same grease that comes stock with Robo 3D R1+/R2 printers. Includes: Grease (1 pcs) Size: 10g

Super Lube® 82340 - Synthetic Grease with SYNCOLON™ (PTFE)  This small size pouch is great for lubing the filament drive gears on dual gear or orbiting gear extruders. Includes: 1 Pouch Size: 1 cc Contains no...

Super Lube 21010 - Synthetic Grease with SYNCOLON™ (PTFE)  Super Lube 21010 is a Prusa Research approved lubricant.   Use on your Bondtech drive gears, Linear bearings or anywhere else you need a high quality grease...

Super Lube® 21030 - Synthetic Grease with SYNCOLON™ (PTFE)  This is a Prusa Research approved lubricant.   Can be used on drive gears, Linear bearings or anywhere else you need a high quality grease. Includes: 1...

  Top Door (Lid) This is the clear plastic lid that encloses the top of the printer. Includes: Top door (1 pcs) Fits: Adventurer 5M ProRobo E4

  Flashforge TFT Touch Screen Includes: Touch Screen (1 pcs) Fits: Adventurer 5M ProRobo E4 Note: Watch the video below for a quick demonstration of how to connect and disconnect the ribbon cable.

  Flashforge TFT Touch Screen Includes: Touch Screen (1 pcs) Fits: Adventurer 5M Note: Watch the video below for a quick demonstration of how to connect and disconnect the ribbon cable.

  Hotend Unclog Pin Helps clear blockages from the hotend Diameter: 1.5mmLength: 133mm Includes: Unclog pin (1 pcs)

  VOC Sensor Assembly Includes: Sensor (1 pcs) Fits: Adventurer 5M ProRobo E4

X/Y Axis Belt Includes: Belt (1pcs) Fits:Adventurer 5MAdventurer 5M ProRobo E4

  Flashforge Z Axis Leadscrew Includes: leadscrew (1 pcs) Fits: Adventurer 5MAdventurer 5M Pro Note: Does not include leadscrew nut