Bambu Smooth PEI Plate for X1 Series, P1 Series, A1 | Bambu Lab

Fits:
Bambu Lab P1 Series
Bambu Lab X1 Series
Bambu Lab A1 (does not fit the A1 mini)

 WARNING  Do not clean the smooth PEI Plate with Acetone, as it will damage the PEI surface.

Notes:
Please apply glue to prevent the sheet from tearing if printing with filaments other than PLA.
The Smooth PEI Sheet cannot be peeled off from the build plates.

Considerations

• If bubbles appear on the bottom of the sheet, heating it on the heatbed at a temperature of no less than 80 degrees for several hours can be helpful in eliminating the bubbles.
• Deposition of dust and grease on the build plate decrease adhesion. It is recommended to regularly clean the surface with detergent and water to to maintain best adhesion.
• Do not clean the Smooth PEI with Acetone, as it will damage the PEI surface.
• Always wait for a few minutes before removing printed models to allow the plate to cool down for easy print removal. This prevents damage to the plate and ensures a long lifetime of the product.
• Carefully sanding the surface with fine-grit (600 was recommended) sandpaper can help restore adhesion.
• The Smooth PEI plate is considered a consumable part, which will degrade over time. The warranty will only cover manufacturing defects, not cosmetic damage like scratches, dents, or cracks. Defective sheets upon arrival are the only ones covered by the warranty.

Installation steps for X1 Series/P1 Series/A1

Step 1: Align the plate with the fixed points of the platform with the name of the plate facing you

 

Step 2: Lower the plate and secure to the magnetic platform