Guider 3

  Flashforge Hotend Air Duct Directs air to the part being printed. Installs on either the left or right side.  Includes: Air duct (1pcs) Fits:Guider 3Guider 3 PlusRobo E4 Pro Note: Does not include mounting screws

  Flashforge Bed Leveling Sensor Switch Includes: Sensor (1 pcs) Fits:Guider 3Guider 3 PlusRobo E4 Pro 

  Flashforge Nozzle Heating Cable Short cable, runs from extruder board to nozzle connection board. Includes: Cable (1 pcs) Fits:Guider 3Robo E4

  Flashforge Extruder Assembly  Includes: Extruder assembly with 0.40mm nozzle (1 pcs) Fits:Guider 3Robo E4 Pro Does not fit Guider 3 Plus

  Flashforge Extruder PCB Board  Includes: Adapter board (1 pcs) Fits: Guider 3Robo E4 Pro

  Filament Drive Gear Includes:Filament drive gear (1 pcs)Set screw (1 pcs) Fits:Guider 3Guider 3 PlusRobo E4 Pro    

  Flashforge Heat Break Includes: Heat break (1 pcs) Fits: Guider 3Guider 3 PlusRobo E4 Pro

  Heater Block (Hot Block) Includes: Heater block (1 pcs) Fits:Guider 3Guider 3 PlusRobo E4 Pro  Note: Does not include the M4x3mm set screw for securing heater cartridge. The set screw may be purchased here. 

  Flashforge Heater Cartridge Includes: Heater cartridge (1 pcs) Fits:Guider 3Guider 3 PlusRobo E4 Pro 

  Flashforge Heatsink Includes: Heatsink (1 pcs) Fits:Guider 3Guider 3 PlusRobo E4 Pro Note: Does not include setscrew for holding heat break or other mounting hardware.

  Flashforge Hotend (Nozzle) Assembly  Includes: Hotend assembly (1 pcs) Nozzle Size: 0.40mm  Fits: Guider 3Guider 3 PlusRobo E4 Pro 

  Extruder to Nozzle Connection Board  This is the board with the female (concave) connector that attaches to the extruder side.  Includes: Connection board (1 pcs) Fits: Guider 3Guider 3 PlusRobo E4 Pro 

  Nozzle to Extruder Connection Board  This is the board with the male (convex) connector that attaches to the nozzle assembly.  Includes: Connection board (1 pcs) Fits: Guider 3Guider 3 PlusRobo E4 Pro

  Flashforge Nozzle Temperature Sensor (Thermocouple) Includes: Temperature sensor (1 pcs) Fits:Guider 3Guider 3 PlusRobo E4 Pro

  Hotend Support Pins These pins go between the heater block and heatsink. Includes: Pin (6 pcs) Fits:Creator 3 ProGuider 3Guider 3 PlusRobo E4 Pro Note: Hotend in picture is not included