Inventor

  Bed Heater Mounting Hardware set This hardware is for mounting the PCB bed heater to the build plate on the below listed Flashforge 3D printers. Includes:Bolts (5 pcs)Nuts (5 pcs) Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2DreamerDreamer...

  Flashforge Bed Leveling Bolt - 3 Pack Includes: Bolts (3 pcs) Fits: InventorDreamerCreator ProCreator Pro 2Creator MaxCreator Max 2 Note: Bed Leveling Nuts and Bed Leveling Springs not included.

   Used Item  Removed from low hour 3D printer. May have minor scratches and/or cosmetic imperfections. Flashforge Build Plate Base (Carriage) This is the carriage that the build plate rides on. Includes: Build plate...

  Flashforge Flexible Spring Steel Build Plate System Includes:Flashforge print surface pre-installed (1 pcs)Magnet sheet with adhesive (1 pcs)Spring steel flexible plate print surface (1 pcs) Max Operating Temperature: 80c Fits:Creator Pro...

   Used Item  Cables are removed from low hour 3D printers. Flashforge Heated Bed Cable This cable runs from the heated bed to the mainboard. Includes: Cable (1 pcs) Fits:Creator ProCreator MaxDreamerDreamer NXInventor

  Heated Build Plate Assembly Comes fully assembled with print surface installed. Includes:Build plate platform (1 pcs)Build plate heater (1 pcs)Print surface (1 pcs) Fits: Creator Pro 2Creator Max 2Creator ProCreator MaxDreamerDreamer...

Replacement Magnet sheet for 154*232mm DFlex™ Build Plate Includes: Sheet magnet with adhesive backing (1 pcs) Size: 154*232mmMax temperature: 90c Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2InventorDreamerDreamer NX

  Flashforge Print Surface Bed Tape Adhesive backed for easy application Includes: Print surface (1 pcs) Size: 153x232mm (can be cut to fit other printers) Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2Inventor (for Inventor 2 bed tape...

  Flashforge Bed Leveling Spring Includes: Spring (1 pcs) Fits:DreamerDreamer NXInventorInventor 2FinderFinder 2Creator ProCreator Pro 2Creator MaxCreator Max 2 Note: Sold in units of 1 - Three springs are required per printer