Inventor

  Bed Heater Mounting Hardware set This hardware is for mounting the PCB bed heater to the build plate on the below listed Flashforge 3D printers. Includes:Bolts (5 pcs)Nuts (5 pcs) Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2DreamerDreamer...

PB Select™ Heatsink Includes: Heatsink (1 pcs) Fits:Creator ProCreator MaxDreamerDreamer NXInventor

PB Select™ Ball End Hex Wrench - L Wrench Includes: Hex wrench (1 pcs) Size: 2.5mm

Heat Resistant Kapton Tape Use this tape to secure the insulation to your Flashforge heater block. Includes: Tape roll (1 pcs) Width: 5mm Length: 33 meters

Motor Mount Bolt for Creator Pro, Inventor and Dreamer Holds the fan, heatsink and motor to the mounting block Includes: M3x40 socket head cap screw (4 pcs) Size: M3x40 Fits:Creator ProCreator MaxInventorDreamer Note: These do not fit the Dreamer NX...

Replacement Magnet sheet for 154*232mm DFlex™ Build Plate Includes: Sheet magnet with adhesive backing (1 pcs) Size: 154*232mmMax temperature: 90c Fits:Creator ProCreator Pro 2Creator MaxCreator Max 2InventorDreamerDreamer NX

MK10 Brass Nozzle for PTFE Lined Hotend Includes: Nozzle (1 pcs) Size: Select Above Fits:Flashforge Guider 2 (not high temp version)Flashforge InventorFlashforge Inventor 2SFlashforge Creator ProFlashforge Creator MaxFlashforge...

MK10 Brass Nozzle (for Microswiss All Metal Hotend Only) Note: Will not fit the stock PTFE lined hotend. This nozzle has completely different internal dimensions to work with the Microswiss thermal barrier tube...

PB Select Nozzle Coat™  Nozzle Coat is a water-based PTFE nano coating for your nozzle & heater block. Using Nozzle Coat will help reduce the amount of plastic that sticks to the exterior of your nozzle & heater block...

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Note: Power supply is not included

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Specs:Wire:18 AGWLength: 72 inches (approximately) Max Operating Temp: 105°C (221°F)

M4X4 Set Screw Used to secure the heater cartridge and heatsink of many Flashforge 3D printers. Includes: M4x4 set screw (1 pcs) Specs:12.9 GradeCup PointUses 2mm Hex Key Driver (not included) Fits:FinderFinder 2Guider 2Guider 2S...

Flashforge Extruder Fan Spacers These are the spacers that reside between the extruder fan and heatsink on some Flashforge 3D Printers. Includes: Spacer (4 pcs) Fits:Creator ProCreator MaxDreamerDreamer NXInventor