Prusa MINI IFS Extruder | Bondtech

  • Bondtech IFS Extruder for Prusa Mini
  • Bondtech IFS Extruder for Prusa Mini
  • Bondtech IFS Extruder for Prusa Mini


Bondtech IFS Extruder for Prusa MINI

This extruder is an evolution of Bondtech's previous high-resolution extruder upgrade for the Prusa MINI.

Allows you to install the Prusa filament sensor (not included) on the MINI or MINI+


  • MINI
  • MINI+

Upgrade Your Prusa MINI or MINI+

  • Designed to seamlessly fit the original setup
  • The extruder may be used with or without the filament sensor
  • Hardened Drive Gears -- use abrasive materials that would wear out the gears of your original feeder otherwise
  • Adjustable tension -- the thumbscrew tensioner allows the user to fine-tune the pressure exerted by the drive gears onto the filament. This gives you the power to adjust according to your preferences and to optimize for the type of material you are using
  • Quick-Release -- to be able to do material changes in a snap, simply activate the quick-release lever to release
  • the tension and pull the material to be changed out of the extruder, keep it activated and insert the new material
  • More choice of materials -- the hardened steel dual drive gears allow you to work with common and abrasive materials

Included in this Kit

  • 1x Bondtech IFS extruder for Prusa MINI
  • 1x 10076-4 IFS Magnet Holder (PA12)
  • 1x 10076-5 IFS Lever (PA12)
  • 1x 15112 IFS Extruder Plug (HT-PLA)
  • 3x Black nylon zip-ties
  • 4x M3x35 black oxide steel screws
  • 1x M3x12 black oxide steel screw
  • 1x Brass motor gear
  • 1x Thumb Screw assembly

Not included in this kit

  • Prusa Filament Sensor
  • Filament Sensor Magnets
  • Filament Sensor Steel Sphere

EAN Code: 7350011413942
Net weight : 114g
Gearing ratio : 3:1
E-steps value : 415
Extruder Housing: SLS Printed parts in PA12
Hinge: injection molded

View AllClose

Additional Information

Bondtech Extruders
Prusa MINI
Prusa MINI+
View AllClose