Robo R2

PB Select™ Plated Copper Nozzle High precision copper nozzles is great for printing everything from PLA to PEEK.Copper has a much higher thermal conductivity than brass and these nozzles can handle high temperatures (up to 495c)...

Downtown Board Screw Set For mounting the Downtown board. Includes: Screws (3 pcs)  Fits:Robo R2Robo C2

PB Select™ GT2 Stepper Motor Drive Pulley Recommended for use with Gates GT2/3 or other GT belts Includes: Idler pulley (1 pcs)Set screw (2 pcs) Fits: 6mm BeltTeeth: 20Width: 7mmBore: 5mmOuter diameter:15mm

PB Select™ GT2 Pulley - 2 Pack Includes:Pulley (2 pcs) Set Screws (4 pcs) Fits: 8mm Linear Rods Specs:20 Tooth7mm Wide (for 6mm belt)8mm Bore  

PB Select™ Ball End Hex Wrench - L Wrench Includes: Hex wrench (1 pcs) Size: 2.5mm

Robo R2 and C2 Hotend Clamping Screw 12.9 grade M3 socket head cap screws used to secure the hotend to the aluminum mounting plate. Use caution when installing your hotend, over-tightening will cause stripping of the threads in the aluminum mounting...

M2.3x6mm Blunt Nose, Pan Head Screw Set Includes: Screws (2 pcs) Head: PanSize: M2.6Length: 6mmType: Blunt nose

PB Select Nozzle Coat™  Nozzle Coat is a water-based PTFE nano coating for your nozzle & heater block. Using Nozzle Coat will help reduce the amount of plastic that sticks to the exterior of your nozzle & heater block...

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Note: Power supply is not included

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Specs:Wire:18 AGWLength: 72 inches (approximately) Max Operating Temp: 105°C (221°F)

Terminal Block Plug 5.08mm Includes: Plug (1 pcs) Specs:4 position15 amp