Tools & Supplies

Bondtech M5 Thread Insert Sold in units of 1. Thread Size: M5  Insert length: 6.6mm Recommended hole diameter: 6.2mm For easy installation use the Heat-Set Insert Soldering Iron Tips

Vibra-Tite Blue Threadlocker  This is a good medium strength thread locker for securing 6mm (or larger) fasteners. For smaller fasteners use purple threadlocker. Includes: 1.8ml Threadlocker (1 pcs) Note: Not intended for use in the hotend...

Vibra-Tite Purple Threadlocker This is a good low strength thread locker for securing small screws on your 3D printer. Includes: 1.8ml threadlocker (1 pcs) Note: Not intended for use in the hotend  Strength: LowColor: PurpleSize: 1.8...

Torx Driver Includes: Torx driver (1 pcs) Size: T6Shaft Length: 3 inchesOverall Length: 6 Inches Fits: Set screws in Nextruder heater block

Torx Driver Includes: Torx driver (1 pcs) Size: T8Shaft Length: 3 inchesOverall Length: 6 Inches Fits: Torx screw holding hall sensor to heatsink. 

Tube Grease for lubing the rods and ball screws of your 3D printer. This is the same grease that comes stock with Robo 3D R1+/R2 printers. Includes: Grease (1 pcs) Size: 10g

  Hotend Unclog Pin Helps clear blockages from the hotend Diameter: 1.5mmLength: 133mm Includes: Unclog pin (1 pcs)

PB Select™ Wi-Fi Adapter ESP-01S for MINI+ (ESP8266 1MB) Fully compatible with the Prusa MINI+ & MK4. Use this wireless adapter to add Wi-Fi to your MINI+ & MK4. Once installed, you can send G-codes from your PC directly to the...

  Flashforge Wrench  For the heat break on some Flashforge 3D printers Includes: Wrench (1 pcs) Size: 6mm Fits:InventorDreamerDreamer NXCreator ProCreator Max Note This is not a nozzle wrench. Nozzle wrench available here. 

Menhir Xtreme Lock Print Bed Adhesive Ensures strong adhesion to a hot print surface. Works with a broad range of of common and exotic filaments.  Size: 120ml  Includes: Bed Adhesive (1 bottle) Note: Does not work with PP...