All Metal Hotend Kit MK8 | Micro Swiss
Micro Swiss MK8 All Metal Hotend Kit
This is an all metal hotend upgrade kit for Flashforge Finder, Inventor 2 and Guider 2 printers
Micro Swiss' all metal hotend allows you to print at much higher temperatures than with PTFE-lined hotend.
Another benefit of this all metal hotend design is more consistent melt chamber control. During slow extrusion rates, the transition zone in PTFE-lined hotends, tends to create more stringy prints. With Micro Swiss' all metal hotend upgrade, the transition zone is always constant, since it is located right at the heat break.
Another reason to upgrade to an all metal hotend is that during faster extrusion speeds, PTFE tubes don't have enough thermal conductivity to properly melt all the filament. All metal hotends solve this problem, as the filament is surrounded by thermally conductive material throughout its length.
- 1 0.40mm plated brass wear-resistant nozzle, made from a 360 brass base material and plated with TwinClad XT coating
- 1 thermal tube
- 2 jam nuts (to aid in removing old hotend)
- MakerBot Replicator 1
- MakerBot Replicator 2
- MK8 Hotends
Tubes: 26mm long
Nozzles: 13mm long
Made in USA by Micro Swiss