Gates

Replacement X-axis belt for MakerGear M3-ID Right Extruder For: X-Axis - Right Extruder (front belt) Fits:  M3-ID Genuine Gates GT Belt Note: If your belts are worn, check your...

Replacement X-axis belt for MakerGear M3-SE Rev.1 and M3-ID Left Extruder For: X-Axis Fits:  M3-SE Rev.1 Only - If you have an M3-SE Rev.0 click here for the proper belt M3-ID left...

Replacement X-axis belt for MakerGear M3 (Rev.0 Only) and M2 3D Printer For: X-Axis Fits:  M3-SE (Rev.0 Only) - If you have an M3-SE Rev.1 click here for the proper belt M2 Genuine...

Replacement 702mm belt for MakerGear M2 and M3 3D Printer For: Y-Axis (Bed) Fits:  M3-ID M3-SE M2 Genuine Gates GT Belt Note: If your belts are worn, check your printer for...

Robo R2 X or Y Axis Belt Set These are the 600mm long belts that run from shaft to shaft on the X and Y axis. Includes: 2 Gates PowerGrip GT3 belts (each axis requires 2 belts - order two sets if...

Robo R2 X/Y Motor-to-Pulley Belt This is the short vertical belt that runs from the stepper motor to the X/Y pulley. Includes: 2 Gates PowerGrip GT3 belts Fits: R2