M2

PB Select™ GT2 Stepper Motor Drive Pulley Recommended for use with Gates GT2/3 or other GT belts Includes: Idler pulley (1 pcs)Set screw (2 pcs) Fits: 6mm BeltTeeth: 20Width: 7mmBore: 5mmOuter diameter:15mm

  Idler Pulley Set for MakerGear 3D Printers Includes:Bolt (1 pcs)Toothed Pulley (1 pcs)Nylon Bushing (1 pcs)  Note: You need one pulley for each belt. Order 2 sets if you need a pulley for each belt. Fits:M3-SEM3-IDM2 Rev G-H 

  Idler Set for MakerGear M2 3D Printers Includes:Bolt (1 pcs)Bearings (3 pcs)E-clip (1 pcs) Fits: M2 Rev A through F Note: for the MakerGear M2 Rev G through H, use the M3 idler set available here

X-axis belt for MakerGear M3 (Rev.0 Only) and M2 3D Printer Genuine Gates GT Belt Includes: Belt (1 pcs) Location: X-Axis Fits: M3-SE (Rev.0 Only) - If you have an M3-SE Rev.1 click here for the proper beltM2 Note: If your belts...

Timing Belt for MakerGear M2 & M3 3D Printer Genuine Gates GT Belt Includes: Belt (1 pcs) Location: Y-Axis (Bed) Length: 702mm Fits: M3-IDM3-SEM2 Note: If your belts are worn, check your printer for alignment issues—misalignment...