M2

PB Select™ Filament Guide Tube for MakerGear Includes: Guide tube (1 pcs) Fits:M2M3

PB Select™ GT2 Stepper Motor Drive Pulley Recommended for use with Gates GT2/3 or other GT belts Includes: Idler pulley (1 pcs)Set screw (2 pcs) Fits: 6mm BeltTeeth: 20Width: 7mmBore: 5mmOuter diameter:15mm

Replacement Magnet sheet for 203*254mm FlexSys™ Build Plate Includes: Sheet magnet with adhesive backing (1 pcs) Size: 203x254mmMax temperature: 90c Fits:MakerGear M2MakerGear M3  

PB Select Nozzle Coat™  Nozzle Coat is a water-based PTFE nano coating for your nozzle & heater block. Using Nozzle Coat will help reduce the amount of plastic that sticks to the exterior of your nozzle & heater block...

PB Select™ Parakeet Bed Clips for MakerGear 3D Printers We designed these low profile bed clips for use with our MakerGear printers The clips have a small beak that just reaches the glass bed to hold it in place. The "beak" that holds the...

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Note: Power supply is not included

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Specs:Wire:18 AGWLength: 72 inches (approximately) Max Operating Temp: 105°C (221°F)

PB Select™ RAMBo to LCD Smart Controller Adapter Connects your LCD Smart Controller display to the RAMBo board on your MakerGear M2.  Comes assembled (you can buy the kit version here: RAMBO/Smart Controller Adapter Kit)...

PB Select™ RAMBo to LCD Smart Controller Adapter This is an unassembled kit that requires soldering to complete. Here is a picture of the assembled adapter for reference when soldering: RAMBO/Smart Controller Adapter assembled This...