PB Select™ Heated Bed Assembly - 24 volt
1. NOT compatible with the MK2/2.5.
2. This is a Prusa compatible bed. If you want the Original Prusa bed, please click here.
3. Flexible spring steel sheet NOT included
Magnetic heat bed MK52 24 volt (1 pcs)
Heat bed-Einsy power cable (screw-attached) (1 pcs)
Heat bed thermistor E3D (already mounted and fixed in place by the aluminum and kapton tapes) (1 pcs)
Textile sleeve (Length: 300 mm, Width: 5 mm) (1 pcs)
Heat bed cable cover (1 pcs)
Heat bed cable cover clip (1 pcs)
Nuts: M3 nylon lock (2 pcs)
Nuts: M3 (3 pcs)
Cap head screws: M3x9 (5 pcs)
Flat head screws: M3x13.5 (9pcs)
Washers: M3 flat (3 pcs)
Height: 264 mm
Width: 254 mm
Thickness: ~3 mm
Maximum working temperature: 110°C
Voltage: 24 volts
Magnets: N35UH Neodym block magnets, attached (28 pcs) - these magnets are not quite as strong as the Original Prusa magnets, but still do a sufficient job of holding the print surface in place.
To replace this part, please consult the Prusa Assembly Manuals. Make sure to follow the manual for your printer model
Print Surfaces, Build Plates & Parts