0.25mm V4 Brass Nozzle for your MakerGear Printer
Sold in units of 1
Suitable for the V4 Hot End, this nozzle is precision-machined in brass.
To swap a nozzle, it is important to remove the hot end from the mount first or the barrel will likely be damaged. Please watch these videos on removing your V4 hot end from the mounting plate and removing the nozzle from your V4 hot end.
Please Note: Once a new nozzle has been installed onto a barrel, do not install that same nozzle onto a different barrel or leakage may occur. As you install a new nozzle onto a barrel, a small amount of material is removed from the nozzle to create a custom fit. This makes the nozzle incompatible with any other barrel due to the slight variations in tolerances among different barrels.