Description
0.35mm V4 Brass Nozzle for your MakerGear printer
Sold in units of 1
Suitable for the MakerGear V4 Hot End, this nozzle is precision-machined in brass.
Please note: To swap a nozzle, it is important to remove the hot end from the mount first or the barrel will likely be damaged. Please watch these videos on removing your V4 hot end from the mounting plate and removing the nozzle from your V4 hot end.
Related Products
MakerGear Compatible H4 Hardened Steel Nozzle for V4 Hotend - 0.40mm
P3-D
$24.95
0.40mm H4 Hardened Steel Nozzle for MakerGear V4 Hot End from Performance 3D
Sold in units of 1
This wear-resistant, high lubricity nozzle is suited for the V4 Hot End.
These...
V4 Thermistor | MakerGear
MakerGear
$20.00
Replacement Thermistor for your MakerGear Printer
This thermistor (temperature sensor) is suitable for both the V3b and the V4 Hot Ends.
If your hot end temperature display seems to be inaccurate,...
V4 Hot End with 0.35mm Brass Nozzle | MakerGear
MakerGear
$85.00
Replacement V4 Hot End for your MakerGear M2 or M3 printer
This V4 Hot End ships fully-assembled, ready-to-install, and includes:
1 - V4 Cartridge Heater
1 - Thermistor
1 - V4 Heater Block
1 -...
MakerGear V4 Stainless Steel Nozzle - 0.35mm
MakerGear
$15.00
0.35mm V4 Stainless Steel Nozzle for your MakerGear printer
Sold in units of 1.
Suitable for the V4 Hot End, this nozzle is precision-machined from stainless steel.
Please note: To swap a nozzle,...
Dyna-Purge® 3D Clean™ 1.75mm | 3D-Fuel
3D-Fuel
$10.00
1.75mm Dyna-Purge® 3D Clean™ Filament Sticks
50 sticks of Dyna-Purge® 3D Clean™ 1.75mm filament arrives in an easy-open tube.
Use Between Materials and Colors: Designed to...
Filament Sentinel - 1.75mm Filament Sensor | Dyze Design
Dyze Design
$39.00
Filament Sentinel - 3D printer filament detector and cleaner
With SENTINEL, the days of prints failed due to a lack of filament or dust on the filament are over!SENTINEL detects your filament and...
