Other

Silicone Sock for CR10S Clearance item: These silicone socks don't have as nice a finish as we would like but they still work great.  Fits: Creality CR-10 Creality CR-10S MK9 Heater...

Battery Low Voltage Shutoff "Blinker Board" - 10 amp Protects tool batteries from over discharge. Max Amps: 10 (if you need to power something more than 10 amps, we recommend using the 3...

Heat Resistant Tape Use this tape to secure the cotton insulation to your Flashforge heater block. Width: 5mm Length: 33 meters

Hotend Cable Guide for R1 Guides the hotend heater and thermistor cable When installing, rotate your hotend 90 degrees so the wires face the front of the printer. Designed by: Bob R...

Ceramic Screwdriver Used for adjusting stepper drivers and other electronics Tip Size: 1.8x0.4mm

Blinker Board - 3 amp Protects tool batteries from over discharge. Max Amps: 3 (if you need to power something more than 3 amps, use a relay) Compatible with: DeWalt, Milwaukee and Makita...

12V Dual Ball Bearing 25mm Fan for Slice Mosquito Hotend 12 volt (find the 24 volt fan here)  3.64 CFM Molex connector 2 bolts included - mount directly to your Slice Mosquito or Mosquito...

24V Dual Ball Bearing 25mm Fan for Slice Mosquito Hotend 24 volt (find the 12 volt fan here)  3.64 CFM Molex connector Hardware included - mount directly to your Slice Mosquito or Mosquito...

DC extension cable A241 - Male to Male  Length: 6 feet Plug: 5.5mm x 2.1mm barrel  

Terminal Block Plug 5.08mm 4 position 15 amp    

Class 10 Micro SD Card - 32 GB  

Heatsink Fan for Robo R1 3D Printers This is the fan that cools heatsink (cold end) of the hotend assembly Fits: R1+  Note: The color of the plug may differ from the photo above.