R1+ Thermistor Wire
Runs from mainboard to thermistor
Will also work for the heatsink fan or print cooling fan but the connector is not keyed so you need to pay attention to the...
3mm Bed Magnets for R1/+ Glass Bed
Please note: These magnets are 3mm thick and do not work with the latest v2.5 R1+ bed, which requires 6mm magnets.
Apply using epoxy and these clamps for...
Robo R1+ Hexagon Hot End Assembly
For 1.75mm filament
Includes:
Complete Hotend12V Heater CartridgeThermistor (the thermistor wire is very delicate, please handle with care)0.40mm Brass...
Robo R1+ Heated Bed Connection Cable
If you currently have a V1 bed with a long cable, you will need this extension cable if you are upgrading to the v2 bed (which has a short cable). Buy...
Robo R1+ RAMPS Board with Stepper Drivers
Please Note: Does not include Arduino MEGA 2560
Fits: R1/+
Important Installation Notes:
Please make sure your printer is turned off and...