Description
Print Bed Plastic Housing for Robo R2
Please note: This is the plastic housing only.
Does not include screws: Reuse the screws from your old bed.
Does not include magnets: Reuse the magnets from your old bed by gently tapping them with a hammer to pop them out.
Additional magnets may be purchased here
Related Products
Bed Magnets - 2 Pack - R2/C2 | Robo 3D
Robo 3D
$2.99
Robo R2/C2 Bed Magnets
Fits: R2/C2
Sold in pack of 2
Bed Carrier Plate - R2 | Robo 3D
Robo 3D
$24.95
Bed Carrier (leveling) Plate for Robo R2
This is the plastic carrier plate only and does not include the acorn nuts or bed leveling hardware
Bed Leveling Hardware (2 Pack) - R2 | Robo 3D
Robo 3D
$5.99
Robo R2 Bed Leveling Hardware - 2 Pack
Includes:
2 Thumb nuts
2 Springs
2 Bolts
Fits: R2
Pogo Adapter for Removable Print Bed - R2 | Robo 3D
Robo 3D
$39.95
R2 Replacement Pogo Adapter
Note: Please read carefully. This Pogo board will need shims for some of the Robo R2 v1 beds.
This adapter will work without shims if you have a v1 bed where...