Description

Double-Sided Powder-coated PA Nylon Spring Steel Sheet for Original Prusa XL (Factory Second Read Below)

This is a FACTORY SECOND product:
It is rated as factory second due to cosmetic and visual defects only. The cosmetic and visual defects do not impact functionality.
Factory second products are completely unused.
Factory second products are fully functional with cosmetic and visual imperfections.
The printed graphic on the factory second steel sheets may differ from the product photo, the graphic has no impact to the functionality of the sheet.
Hairline scratches, visual imperfections of the graphics (missing, blurred), imperfections on the print surface (dents, bumps)

This print sheet is specially designed to print polyamide-based filaments, especially the Prusament PA11 Carbon Fiber Black. The PA11-type materials have generally a lower adhesion on textured or satin print sheets. This sheet has a special surface finish that increases the adhesion and is perfect for Prusament PA11. You can learn more about the Double-sided Powder-coated PA Nylon Spring Steel Sheet in our knowledgebase.

IMPORTANT
Do not clean with IPA or Acetone
The surface of this sheet should be cleaned only with pure water. Using common agents such as IPA or Acetone will lead to a quick deterioration of the surface.
Using a glue stick is no longer required and recommended. To clean grease-coated areas, use clean water with a drop of dishwashing detergent.
Suitable only for polyamide-based materials and PETG. Other materials tend to detach mid-print
Can be damaged with IPA and acetone

Filament compatibility

Includes: PA-nylon spring steel sheet - factory second (1 pcs)

Fits: Prusa XL

Attributes:
Great for Polyamide based materials
No need for glue stick
Can be cleaned just with water

Prusa Notes:
Consumable parts, such as PEI sheets (smooth, textured, nylon, etc.) are not covered by warranty as the coatings are designed to diminish over time unless failure has occurred due to a defect in materials or workmanship. Cosmetic damage, including but not limited to scratches, dents, cracks or other cosmetic damage is also not covered by the warranty. Only defective sheets on arrival are covered by warranty.

As a result of the temperatures to which the plate is exposed during printing, its surface gradually becomes glossier or may develop smaller, duller areas. This visual change does not adversely affect the printing properties and is not considered a reason for a warranty claim.

Note that with the Original Prusa XL, the PA Nylon sheet wear is especially noticeable at the Z probing points, where the nozzle leaves visible marks on the surface. This does not affect the surface adhesion and overall printability. You can examine the marks in our knowledge base article.

Factory second product, fully functional with cosmetic and visual imperfections