M2 Replacement Extruder Fan 50x50x10mm, 12 volt for your MakerGear M2 3D printer
Mounted at a 45 degree angle in front of the extruder's 40mm fan, this 50 mm fan provides users with greater control over the cooling rate of extruded filament material.
This fan has a keyed connector, guarding against incorrect plug-in. All fans should be kept free of dust buildup to prevent failure.
* Depending on when you purchased your M2, you may need a 24 volt 50 mm fan. If you are unsure which fan you need, you can examine the label on your current fan to verify its voltage.