Description
Replacement Pinion Gear for MakerGear 3D Printers
Fits the extruder stepper motor for all MakerGear M2 and M3 Printers
Use Loctite 609 to attach to motor shaft.
Additional Information
Fits: |
M2 |
Fits: |
M3 SE |
Fits: |
M3 ID |
Category: |
Stepper Motors |
Category: |
Extruder & Hotend |
Related Products
8x10 Glass Build Surface | MakerGear
MakerGear OEM
$26.00
8x10 Build Surface from MakerGear
Made from borosilicate glass, this 8" x 10" x 0.13" (20 cm x 25 cm x 3.3 mm) build plate provides a perfect print surface when properly coated in a film of...
8x10 Original BuildTak Sheet - MakerGear M2 & M3
BuildTak
$14.95
BuildTak Sheet - an ideal build surface for the MakerGear M2 & M3
Sold in units of one
8x10 inches (203x254 mm)
Creates an optimal bond between the 3D printed object and build...
40x10mm 24v Extruder Fan | MakerGear
MakerGear OEM
$15.00
Replacement Extruder Fan 40x10mm, 24 volt for your MakerGear M3/M2* 3D printer
This is the smaller of the two fans mounted in front of the extruder and also used inside the electronics case...
Dyna-Purge® 3D Clean, 1.75mm | 3D-Fuel
3D-Fuel
$14.95
1.75mm Dyna-Purge® 3D Clean™ Filament Sticks
50 sticks of Dyna-Purge® 3D Clean™ 1.75mm filament arrives in an easy-open tube.
Please Note: Not recommend for Bowden drives. For...
PETG - HDglass Fluor Clear Stained (Slightly Translucent) - 1.75mm 750g | Formfutura
Formfutura
$39.95
Fluor Clear Stained HDglass PETG by Formfutura
Slightly Translucent. Heavy duty premium PETG filament that prints with a beautiful high gloss finish and shine.
HDglass Filament Print...
PETG - HDglass Clear (Translucent) - 1.75mm 750g | Formfutura
Formfutura
$39.95
Clear HDglass PETG by Formfutura
Heavy duty premium PETG filament that prints with a beautiful high gloss finish and shine.
HDglass Filament Print Settings
These settings are recommended by...
