DDX Adapter Set For Creality Ender-3 / CR-10 | Bondtech
DDX Adapter Set For Creality Ender-3 / CR-10
Note: Does not fit DDX V3
This set is necessary to install a DDX Upgrade Kit on the models listed below.
- CR-10 S4
- CR-10 S5
Requires your printer to have a 40x40x10mm Radial Fan.
When upgrading an Ender-3 or CR-10 be aware firmware changes are almost impossible. These models are limited to the original hotend and the e-steps value has to be declared on the start g-code in the slicer.
STEP BY STEP GUIDES
These guides are provided by bondtech and apply to the DDX Direct Drive eXtruder for Creality.
Guides For Ender-3 and similar