Parts, Accessories & Supplies

Adapter Direct - Bowden for 3mm diameter filament CNC-machined in aluminum with a mounted push-fit connector for 6mm tube. Use this adapter in the groove mount where the hot-end is located to fit your Bowden tube - see center image below.

Bowden Collet with Clip Replacement Collet for our RepRap V6 Heatsinks Suitable for 4mm OD Bowden tube Fits:  PB Select™ V6 Heatsink Orbiter Extruder V2.0 Includes: Push fit collet (1 pc) Collet clip (1 pc) Does not fit E3D...

Set of 3 Bowden Collets for Micro Swiss CR10 Hotend kit Fits: Micro Swiss hotend for CR-10 / Ender Kit Micro Swiss hotend for CR-10s Pro Kit

Bowden Tube Cutter for PTFE Tubing This handy little tool easily makes super clean cuts in PTFE tubing. Buy premium Capricorn PTFE tubing here.  

Bowden Tube Cutter for PTFE Tubing This handy little tool easily makes super clean cuts in PTFE tubing. Buy premium Capricorn PTFE tubing here.    

Brass Heater Block Fits: E3D V6 RepRap Prusa i3

5 Amp DC-DC Buck Converter XL4015 Input voltage 4.0 ~ 38V Adjustable output voltage range 1.25V ~ 35V (Input voltage must be higher than the output voltage by 1.5V) Output current 4A recommended (up to 5A) Power indicator light Includes...

BuildTak Nylon+ Manufactured here in the US to ensure consistent quality and composition, BuildTak Nyon+ build surface is equipped with the no-cleanup BuildTak Original adhesive for easy removal.  We have been printing Taulman3D Alloy 910...

Robo R2 BuildTak Print Surface - 3 Pack Pack of 3 replacement Buildtak sheets. Fits: R2 Note: Works well with most filaments, however, for printing PETG, we recommend a PEI print surface Care should be taken to check the Z height when changing...

Robo R2 BuildTak Print Surface Original Buildtak sheet. Sold in units of 1. If you are printing with PETG, we recommend using a PEI print surface instead. Please Note: Care should be taken to check the Z height when changing filaments, as...

Bondtech PC2510 to JST-XH6 Cable PC2510 4-pin connector to JST-XH6 6-pin connector. This cable is by default wired for the Bondtech 40mm geared Nema17 motor. Please make sure that it follows the schematics for your application. Controller side ...

Bondtech Dupont Cable Dupont cable 4-pin connector to 6-pin connector. This cable is by default wired for the Bondtech 40mm geared Nema17 motor. Please make sure that it follows the schematics for your application. Controller Side   ...