Revo

Revo

  • E3D 3010 12 volt Fan

    Fan - 30mm 12v | E3D

    E3D

    $7.99
      E3D Dual Ball Bearing Fan - 30mm 12v These fans have the E3D seal of approval. Use for E3D HotEnds, Extruders or anywhere else you need a good quality ball bearing fan. Include: Fan (1 pcs) Specs:Size: 30x30x10mmVoltage: 12 VDCAmps: 0.10Wire...
    $7.99
  • E3D 30x30x10 DC fan - 24 volt

    Fan - 30mm 24v | E3D

    E3D

    $7.99
    E3D Hotend Fan - Ball Bearing - 30mm 24v These fans have the E3D seal of approval. Use for E3D HotEnds, Extruders or anywhere else you need a good quality ball bearing fan. Includes: Fan (1 pcs) Size: 30x30x10mmVoltage: 24 VDCLeads: 1mConnector: 2...
    $7.99
  • Revo Micro Fan

    Fan for Revo Micro - 20mm - 5 volt | E3D

    E3D

    $14.99
    5 Volt Fan for Revo™ Micro Includes:  Fan (1 pcs) Voltage: 5 voltsSize: 20x20x10mm  Warning  This fan must be connected using the 5V regulator unless connecting directly to a 5V pin.
    $14.99
  • Nozzle Coat™ for 3D Printing

    Nozzle Coat™ | 4ml

    PB Select™

    $14.99
    Nozzle Coat™  Nozzle Coat is a water-based PTFE nano coating for your nozzle & heater block. Using Nozzle Coat will help reduce the amount of plastic that sticks to the exterior of your nozzle & heater block. Includes:...
    $14.99
  • Revo Micro Fan Regulator

    Regulator for Revo Micro Fan | E3D

    E3D

    $14.99
    Fan Regulator for Revo™ Micro Drops voltage to 5 volts. For use with E3D Micro Revo Fan. Includes: Regulator (1 pcs) Max Input: 24 volts
    $14.99
  • Revo Nozzle Pack

    Revo Brass Nozzle - Single or Triple Pack | E3D

    E3D

    $22.95 - $57.95
    Revo™ Brass Nozzle Single Nozzle Includes: Revo nozzle of selected size (1 pcs)ORTriple pack includes: 1 each of 0.25, 0.60 & 0.80mm nozzles Fits: All E3D Revo hotends Notes: - You may need to adjust your Z offset when changing...
    $22.95 - $57.95
  • Revo CR Heater

    Revo CR Heater Core for Creality | E3D

    E3D

    $31.99
    Revo™ CR HeaterCore for Creality - 24 volt This is a special Revo HeaterCore intended for use with the Revo CR. It uses a 40W heater and a 100K NTC thermistor, which has the same response as a stock Creality thermistor, saving you the...
    $31.99