Robo R1

Robo R1+ Heated Bed Connection Cable  You will need this extension cable if you are upgrading from a v1 bed (with a long cable) to the v2 bed (which has a short cable).  Includes: Cable (1 pcs) Fits: Robo R1+ with v2 bed

SD to RAMPs cable Connects SD card reader to RAMPs board. Includes: Cable (1 pcs) Fits:Robo R1Robo R1+

Cable for Extruder Motor  Runs from extruder motor to mainboard of Robo R1+  Includes: Cable (1 pcs) Fits: Robo R1+Robo R1

Power Supply Cable This cable runs from the power inlet to the power supply of the Robo R1+ Includes:  Cable (1 pcs) Fits:Robo R1Robo R1+

R1+ Fan Cable (Wire) Runs from mainboard to print cooling fan. Will also work for the heatsink cooling fan, but the wires will need to be reversed or the fan runs backwards.  Includes: Cable (1 pcs) Fits: R1+

R1+ Thermistor Cable (wire) Runs from mainboard to thermistor.Will also work for the heatsink fan or print cooling fan but pay attention to the orientation of the plug (at the mainboard) so the fan does not run backwards. Includes: Cable...

Cable (wire) for X endstop limit switch Includes: Cable (1 pcs) Fits: Robo R1Robo R1+

X Stepper Motor Cable for Robo 3D Printers This cable is for the R2 X motor but also fits the Robo C2 and R1/+ Includes: Cable (1 pcs) Length: 700mm Fits: R2C2R1R1+

Cable (wire) for Y endstop limit switch Includes: Cable (1 pcs) Fits:Robo R1Robo R1+

Cable (wire) for Z endstop limit switch Includes: Cable (1 pcs) Fits: Robo R1+

Robo R1/R1+ Heater Cartridge Extension Cable Extension cable for R1/R1+ heater cartridge  This cable has a plug on one end to plug into the R1/R1+ heater cartridge wire and bare wires (no plug) at the other end, so it will attach to your current...

Hotend Cable Guide for R1 Guides the hotend heater and thermistor cable When installing, rotate your hotend 90 degrees so the wires face the front of the printer. Designed by: Bob R.  

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Note: Power supply is not included

Power Supply Cord AC power cord that runs from the power supply to a USA type wall outlet  Includes: Power cord (1 pcs) Specs:Wire:18 AGWLength: 72 inches (approximately) Max Operating Temp: 105°C (221°F)

4 Position, 90 Degree Right Angle, Terminal Block Header Includes: Header (1 pcs) Amps: 12Pitch: 5.08mm  

Terminal Block Plug 5.08mm Includes: Plug (1 pcs) Specs:2 position20 ampSafety approval:  Shade of green may be different than photo

Terminal Block Plug 5.08mm Includes: Plug (1 pcs) Specs:4 position15 amp

4 Position Vertical Terminal Block Header Includes: Header (1 pcs) Amps: 12Pitch: 5.08mm